Component Removal And Replacement; Front Bezel And Top Cover - HP j6700 - Workstation Upgrade Instructions

Component Remove/Replacement

Component Removal and Replacement

Component Removal and Replacement
The procedures in this section describe how to remove the components from your
workstation. You can follow the same procedures in reverse to replace or install new
accessories or components. Observe the electrostatic discharge (ESD) precautions and the
prerequisites for removing and replacing components or accessories as discussed in
Chapter 1. Also, read any NOTEs, CAUTIONs, and WARNINGs in each component or
accessory removal and replacement procedures.

Front Bezel and Top Cover

This section describes how to remove and replace the J6700 workstation's front bezel and
top cover.
Note that you can perform certain operations, like removing and replacing hard disk
drives, simply removing the front bezel of the workstation. Other operations require more
access to the interior of the workstation, so you will need to remove the front bezel or top
panel to perform those procedures.
CAUTION The system will not operate with the top panel removed.
10 Chapter 2