Table of Contents
Advertisement
minimal pressure.
When the chip is fully seated in the socket, pivot the microprocessor-socket release lever back toward the socket until it snaps into place,
securing the chip.
Figure 29. Microprocessor Chip Installation
CAUTION: Ground yourself by touching an unpainted metal surface on the back of the computer.
11. Unpack the heat sink included in your upgrade kit.
Peel the release liner from the adhesive tape that is attached to the bottom of the heat sink.
12. Place the heat sink on top of the microprocessor chip (see Figure 30).
Figure 30. Heat Sink Installation
13. Replace the heat sink securing clip.
Orient the clip as shown in Figure 30, and hook the unfolded end of the clip over the tab on the top edge of the socket. Then press down on
the folded end of the clip to snap the clip over the tab on the bottom edge of the socket.
14. Replace the fan assembly and secure it with two thumbscrews. Then connect the fan power cable to the FAN connector on the system
board .
15. Install the microprocessor fan cable connector to the FAN connector on the system board.
16. Replace the computer cover, and then reconnect your computer and peripherals to their power sources and turn them on.
As the system boots, it detects the presence of the new microprocessor and automatically changes the system configuration information in
System Setup.
17. Enter System Setup and confirm that the Microprocessor option correctly identifies the installed microprocessor.
18. Run the Dell Diagnostics to verify that the new microprocessor operates correctly.
1
Pin-1 corners of chip and socket aligned
1 Fan screws (2)
2 Fan
3 Securing clip
4 Heat sink
5 Celeron™ microprocessor
6 Microprocessor ZIF socket
Advertisement
Table of Contents
