Table of Contents
Advertisement
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the
chassis intrusion detector.
Figure 23. Expansion Card Installation
CAUTION: Use a wrist grounding strap as explained in
CAUTION: Some network cards automatically start up the system when they are connected. To
guard against electrical shock, be sure to unplug your computer from its electrical outlet before
installing any expansion cards
To install an expansion card, perform the following steps:
1. Prepare the expansion card for installation, and
See the documentation that came with the expansion card for information on configuring the card, making internal connections, or otherwise
customizing it for your system.
2. Remove the screw and remove the metal filler bracket that covers the card-slot opening for the expansion slot you intend to use (see Figure
24).
Save the screw to use when installing the expansion card later in this procedure.
Figure 24. Filler Bracket Removal
3. Insert the expansion card into the expansion-card connector.
If the expansion card is full-length, insert the front end of the card into the corresponding card guide on the inside front of the chassis as you
insert the card into its connector. Insert the card's edge connector firmly into the expansion-card slot.
4. When the card is firmly seated in the connector, secure the card's mounting bracket to the chassis with the screw you removed in
5. Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
6.
Replace the computer
cover, and reconnect your computer and peripherals to their power sources and turn them on.
NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be displayed at the
next system start-up:
ALERT! Cover was previously removed.
7. To reset the chassis intrusion detector, enter System Setup and reset Chassis Intrusion to Enabled or Enabled-Silent.
1 Expansion card
2 Card-edge connector
3 Riser board
4 Expansion-card connector
5 Expansion-card cage
"Precautionary
remove the computer
cover.
1 Filler bracket
Measures."
step
2.
Advertisement
Table of Contents
