Table of Contents
Advertisement
Drives
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
WARNING:
To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
WARNING:
Do not operate your equipment with any cover(s) (including computer
covers, bezels, filler brackets, front-panel inserts, etc.) removed.
Removing a Hard Drive
CAUTION:
If you are replacing a hard drive that contains data that you want to
keep, back up your files before you begin this procedure.
1 Follow the procedures in "Before You Begin" on page 11.
2 Remove the computer cover from both the sides (see "Removing the
Computer Cover" on page 15).
3 Disconnect the power cable and the data cable from the hard drive.
NOTE:
If you are not replacing the hard drive at this time, disconnect the
other end of the data cable from the system board and set it aside. You can
use the data cable to install a hard drive at a later time. For the location of the
SATA connectors, see "System Board Components" on page 8.
7
31
Drives
Advertisement
Table of Contents
