Table of Contents
Advertisement
Power Supply
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
WARNING:
To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
WARNING:
Do not operate your equipment with any cover(s) (including computer
covers, bezels, filler brackets, front-panel inserts, etc.) removed.
Removing the Power Supply
1 Follow the procedures in "Before You Begin" on page 11.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 15).
3 Disconnect the DC power cables from the system board and the drives.
Note the routing of the DC power cables underneath the tabs in the
computer chassis as you remove them from the system board and drives.
You must route these cables properly when you replace them to prevent
them from being pinched or crimped.
4 Remove all the cables from the securing clip on the side of the power
supply.
5 Remove the four screws that attach the power supply to the back of the
computer chassis.
13
Power Supply
63
Advertisement
Table of Contents
