Brother Simplicity SB530T Operation Manual page 18

KNOWING YOUR SEWING MACHINE — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
While holding the spool with your right
7
hand, pull the thread with your left hand,
and then pass the thread under the thread
guide A.
1
1 Thread guide A
Pass the thread under the thread guide
8
cover from the back to the front.
Hold the thread with your right hand so that
there is no slack in the thread that is pulled
out, and then pass the thread under the thread
guide B with your left hand.
1 Thread guide B
Pull the thread to the right, pass it under
9
the hook of the bobbin-winding thread
guide, and then wind the thread
counterclockwise between the discs,
pulling it in as far as possible.
1 Hook of the bobbin-winding thread guide
2 Pre-tension disk
17
0
a
●
a
b
c
●
While using your left hand to hold the
thread that was passed through the bobbin-
winding thread guide, use your right hand
to wind the end of the thread clockwise
around the bobbin five or six times.
Pass the end of the thread through the slit
in the bobbin winder seat, and then pull
the thread to the right to cut it.
a
1 Slit in bobbin winder seat (with built-in cutter)
The thread is cut to a suitable length.
CAUTION
Be sure to cut the thread as described. If
the bobbin is wound without cutting the
thread using the cutter built into the slit
in the bobbin winder seat, the bobbin
may not be wound correctly. In addition,
the thread may become tangled in the
bobbin or the needle may bend or break
when the bobbin thread starts to run out.
Press the foot controller to start.
When the bobbin seems full and begins
spinning slowly, take your foot off the foot
controller.
CAUTION
When the bobbin winding becomes
slow, stop the machine, otherwise the
sewing machine may be damaged.