Power Supply; Connecting The Power Cable; Adjusting Monitor Angle - Panasonic BT-LH1850 Operating Instructions Manual

Power supply

Connecting the power cable

1.
Attach the power cable to the unit.
2.
Connect the power cable to an AC outlet.

Adjusting monitor angle

Move the unit in the direction of the arrows to adjust it to a comfortable viewing position.
Approx. 10 degrees
Forward
• The tilt stand allows you to tilt the unit approx. 10 degrees forward and approx. 15 degrees backward.
Power cable
Approx. 15 degrees
Backward
„ When using external DC power (12 V DC)
„
You can slide open the power cover to switch from AC input to
external DC input.
Power cover
<Note>
• If the power cover has come off or been removed, do not use
the monitor with the power supply connected to both AC input
and DC input terminals.
• Use a shielded DC cable that is not longer than 2 m. A cable
that is 2 m or longer may cause noise.
If an external DC power supply is used, be sure to check that
the rating of the external DC power supply suits the power
requirements of this unit.
When using external DC power (12 V DC), check the external
DC input terminal pin signal, and use the correct polarity. If
a +12 V power supply is accidentally connected to the GND
terminal, this could cause a fire or personal injury.
4
1
2 3
External DC input terminal
Pin number Signal
1 GND
2, 3 ―
4 +12 V
13