Post-Installation Configuration For Red Hat Enterprise Linux 3.0 And 4.0 - HP StorageWorks 500 - G2 Modular Smart Array User Manual

Open a console prompt.
2.
Mount the CD-ROM.
3.
Change to the Linux directory.
4.
List the contents of the directory and select the proper RPM for the current operating system.
5.
Install the proper RPM using the following command:
6.
#rpm_-Uhv --replacefiles cpq_cciss_<os version> .i686.rpm
After successful installation, reboot the server.
7.
Repeat steps 1 through 7 for each server connected to the MSA500 G2 storage system.
8.
Post-installation configuration for Red Hat Enterprise Linux
3.0 and 4.0
After installing Smart Array Multipath software on a server with a Red Hat Enterprise Linux operating
system, configure for multipath operations.
Review the following sample configuration procedure. This sample assumes that the user wants to set
/dev/cciss/c1d0p2 and /dev/cciss/c2d0p2 to point to the same volume as a multipath device.
To configure the system for multipath use:
Be sure that the MSA500 G2 storage system contains two identical MSA500 G2 controllers
1.
connected to the same logical volume.
To create multipath device /dev/md0, run:
2.
mdadm -–create -–level multipath –n 2 /dev/md0 /dev/cciss/c1d0p2
/dev/cciss/c2d0p2
To review the status, run:
3.
mdadm –D /dev/md0
Results should look similar to the following:
/dev/md0
Version : 00.90.00
Creation Time : Mon Apr 29 09:15:00 2003
Raid Level : multipath
Array Size : 14683328 (14.00 GiB 15.08 GB)
Raid Devices : 2
Total Devices : 2
Preferred Minor : 0
Persistence : Superblock is persistent
Update Time :
State : dirty, no-errors
Active Devices : 2
Working Devices : 2
Failed Devices : 0
Spare Devices : 0
Number Major
0 106 2
Mon Apr 29 09:02:00 2003
Minor RaidDevice
0 active sync
Installation and operation in Red Hat Enterprise Linux 3.0 and 4.0 environments 22
State
/dev/cciss/c2d0p2