Table of Contents
Advertisement
22
What to do if ...
Problem
Display changes between two
heat settings
f
flashes
_
is lit
e
and number are displayed
e
and minus are displayed
If you are unable to remedy the problem by following the above sugges
tions, please contact your local Service Force Centre.
Warning! Repairs to the appliance are only to be carried out by qualified service
engineers. Considerable danger to the user may result from improper repairs.
If the appliance has been operated incorrectly, the visit from the service techni
cian or dealer may not take place free of charge, even during the warranty peri
od.
Possible cause
Power Management is reduc
ing the power of this cooking
zone
Power Management is active,
maximum load per side
reached
Unsuitable cookware
No cookware on the cooking
zone
Diameter of the base of the
cookware is too small for the
cooking zone
Cookware not completely cov
ering cross
Overheating protection for the
cooking zone has been trig
gered
Automatic switch off has been
triggered
Electronics fault
Light rays that are too strong
on the control panel, for ex
ample bright sunlight
Remedy
See the section " Switching
the power function on and
off"
Use cooking zones on other
side
Use suitable cookware
Put cookware on zone
Use suitable cookware (min.
120 mm)
Place cookware centrally over
the cross
Switch off the cooking zone.
Switch the cooking zone on
again
Switch off the cooking zone.
Switch the cooking zone on
again
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system)
If after switching on again,
is displayed again, call the cus
tomer service department
Briefly shade the control pan
el, for example with the hand
Acoustic signal sounds, appli
ance switches itself off Switch
appliance on (again)
e
Advertisement
Table of Contents
