Easy Setup; Speaker Settings Menu - Sony STR-DH740 Operating Instructions Manual

Easy Setup

Re-runs the Easy Setup to make the basic
settings. Follow the on-screen instructions
(page 30).

Speaker Settings menu

You can adjust each speaker manually.
You can also adjust the speaker levels after
the Auto Calibration is completed.
Note
The speaker settings are only for the current
seating position.
x Auto Calibration
Lets you perform Auto Calibration from
your seating position.
1
Follow the instructions on the TV
screen, then press
The measurement starts in five seconds.
The measurement process will take
approximately 30 seconds with a test
tone.
When the measurement ends, a beep
sounds and the screen switches.
Note
If an error code appears on the screen, see
"Message list after Auto Calibration
measurement" (page 60).
2
Select the item you want, then press
.
• Retry: Performs the Auto Calibration
again.
• Save&Exit: Save the measurement
results and exits the setting process.
• WRN Check: Displays warning
related to the measurement results. See
"Message list after Auto Calibration
measurement" (page 60).
• Exit: Exits the setting process without
saving the measurement results.
3
To check the Auto Calibration
results
To check error code or warning message
.
obtained in "Auto Calibration" (page 59),
proceed with the following steps.
Select "WRN Check" in step 2 in "Auto
Calibration" (page 59) then press
If a warning message appears, check the
message and use the receiver without
change.
Or if necessary, perform Auto Calibration
again.
When "Error Code" appears
Check the error and perform Auto
Calibration again.
1
2
3
Save the measurement result.
Select "Save&Exit" in step 3.
Note
If you reposition your speaker, we recommend
that you perform Auto Calibration again to
enjoy the surround sound.
Tips
• You can change the unit of distance in
"Distance Unit" in the Speaker Settings
menu (page 62).
• The size of a speaker ("Large"/"Small") is
determined by the low frequency
characteristics. The measurement results
may vary, depending on the position of the
optimizer microphone and speakers, and the
shape of the room. It is recommended that
you apply the measurement results.
However, you can change those settings in
the Speaker Settings menu. Save the
measurement results first, then try to change
the settings.
Press .
"Retry ?" appears on the TV screen.
Select "Yes", then press
Repeat steps 1 to 3 in "Auto
Calibration" (page 59).
.
.
59
GB