Compaq StorageWorks 3000 - RAID Array Release Note page 12

Compaq StorageWorks RAID Array 3000 for Microsoft Windows
StorageWorks Command Console SWCC
This version of SWCC software is for use with the StorageWorks HSZ22 controllers
only. This product CANNOT be used for configuring any other StorageWorks
controllers. The following is a list of known issues and limitations of the SWCC Client
software:
I
Initial Configuration – The SWCC Client requires one serial connection for each
controller in the RA3000 subsystem for initial configuration. The initial
configuration of a dual controller system requires a PC with two serial ports. You
must connect each controller to a different communications port on the PC on which
the SWCC Client software is running. Check the Getting Started RAID Array 3000
for Microsoft Windows Installation Guide, AA-RACZD-TE) for details. If the PC is
equipped with a single serial port, refer to the RAID Array 3000 Subsystem Second
Controller Option Guide (EK-SM3KC-IG.E01).
I
Firmware Download – If you must upgrade the controller firmware, you must
connect via the SCSI bus or network. If the boot device is located on the RA3000,
refer to the Read Me File on the CD-ROM, which explains how to download
firmware using a serial connection.
Page 12 AA–RAD0D–TE