Electrical Connections - LG LSCI307ST User's Manual & Installation Instructions

ELECTRICAL CONNECTIONS

IMPORTANT SAFETY INSTRUCTIONS
• Be sure your cooktop is installed and grounded
properly by a qualified installer or service technician.
• This cooktop must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No. 70,
latest edition in the United States.
WARNING
The electrical power to the cooktop must be shut
off while line connections are being made. Failure
to do so could result in serious injury or death.
ELECTRICAL REQUIREMENTS
Observe all governing codes and local
ordinances.
A 3-wire or 4-wire single-phase 120/240 or
1
120/208 volt, 60 Hz AC-only electrical supply is
required on a separate circuit fused on both sides
of the line (time-delay fuse or circuit breaker is
recommended). DO NOT fuse neutral. The fuse
size must not exceed the circuit rating of the
appliance specified on the nameplate.
This unit can consume up to 7,400W at 240 VAC.
2
A 40 Amp circuit breaker with wire gauge #8 AWG
must be used.
NOTE: Wire sizes and connections must conform
with the fuse size and rating of the appliance in
accordance with the National Electrical Code
ANSI/NFPA No. 70, latest edition, and local codes
and ordinances.
WARNING
An extension cord must not be used with this
appliance. Such use may result in a fire, electrical
shock, or other personal injury.
I N S TA L L AT I O N I N S T RU C T I O N S
PROVIDING THE ELECTRICAL
CONNECTION
Install the junction box under the cabinet and run
120/240 or 120/208 volt, AC wire from the main
circuit panel.
NOTE: DO NOT connect the wire to the circuit
panel at this time.
The appliance should be connected to the fused
3
disconnect (or circuit breaker) box through flexible
armored or nonmetallic sheathed cable. The
flexible armored cable extending from this
appliance should be connected directly to the
grounded junction box. The junction box should be
located as shown on page 22 with as much slack
as possible remaining in the cable between the
box and the appliance, so it can be moved if
servicing is ever necessary.
A suitable strain relief must be provided to attach
4
the flexible armored cable to the junction box.
23