Jumper Settings - Asus TX97-L User Manual

III. INSTALLATION

Jumper Settings

1. Flash ROM Boot Block Programming (BBLKW)
This sets the operation mode of the boot block area of the Programmable Flash
ROM to allow programming in the Enabled position. This is required only if
prompted by the Flash Memory Writer Utility as shown in BIOS SOFTWARE.
Programming
Disabled
Enabled
Thermal
Sensor
Boot Block Programming
2. Real Time Clock (RTC) RAM (CLRTC)
The CMOS RAM is powered by the onboard button cell battery. To clear the
RTC data: (1) Turn off your computer, (2) Short solder points, (3) Turn on your
computer, (4) Hold down <Delete> during bootup and enter BIOS setup to re-
enter user preferences.
RTC RAM CLRTC
Clear Data [short solder pointS (Position R73) momentarily]
Thermal
Sensor
RTC RAM (Clear Data)
BBLKW
[1-2] (Default)
[2-3]
BBLKW
1
2
3
Disabled/Protect
(Default)
R
CLRTC
Short solder points
to Clear Data
R
ASUS TX97-L User's Manual
BBLKW
1
2
3
Enabled
15