Asus TX97-L User Manual page 29

III. INSTALLATION
9. ATX Power Supply Connector (ATXPWR, 20-pin block)
This connector connects to a ATX power supply. The plug from the power supply
will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT: Make sure that your ATX power supply can supply at least
10mAmp on the 5-volt standby lead (5VSB). You may experience difficulty in
powering on your system if your power supply cannot support the load. For
Wake on LAN support, your ATX power supply must supply at least 720mAmp.
Thermal
Sensor
ATX Power Connector
10. AT Power Supply Connector (POWER, 12-pin block)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. Orient the connectors so that the black wires are together.
Thermal
Sensor
AT Power Connector
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.
+3.3 Volts
-12.0 Volts
Ground
Power Supply On
Ground
Ground
Ground
-5.0 Volts
+5.0 Volts
+5.0 Volts
R
+5V
GND
+12V
PG
Power Connector
on Motherboard
R
ASUS TX97-L User's Manual
+3.3 Volts
+3.3 Volts
Ground
+5.0 Volts
Ground
+5.0 Volts
Ground
Power Good
+5V Standby
+12.0 Volts
RED
RED
RED
-5V
WHT
BLK
BLK
BLK
BLK
BLU
-12V
YLW
RED
+5V
ORG
Power Plugs from
Power Supply
P9
P8
29