Asus TX97-L User Manual page 13

III. INSTALLATION
Jumpers
1) BBLKW
2) CLRTC
3) KBWK
4) FS0, FS1, FS2
5) BF0, BF1, BF2
6) VID0, VID1, VID2
Expansion Slots
1) DIMM Sockets
2) CPU ZIF Socket 7
3) SLOT 1, 2, 3
4) PCI 1, 2, 3, 4
Connectors
1) KB
2) FLOPPY
3) PRINTER
4) COM1, COM2
5) FAN
6) CHASSIS
7) Primary / Second IDE
8) IDELED
9) ATX POWER
10) AT POWER
11) USBIRMS
12) IR
13) MSG.LED (PANEL)
14) SMI (PANEL)
15) PWR SW. (PANEL)
16) RESET (PANEL)
17) PWR.LED (PANEL)
18) KEYLOCK (PANEL)
19) SPEAKER (PANEL)
20) W0LCON
*
The onboard hardware monitor uses the address 290H-297H so legacy ISA cards
must not use this address or else conflicts will occur.
p. 15 Flash ROM Boot Block Program (Disable/Enable)
p. 15 Real Time Clock RAM (Clear Data)
p. 16 Keyboard Power Up (Enable/Disable)
p. 16 CPU External Clock (BUS) Frequency Selection
p. 16 CPU:BUS Frequency Ratio
p. 18 CPU Voltage Selection
p. 19 168-Pin DIMM Memory Expansion Sockets
p. 22 Central Processing Unit (CPU) Socket
p. 23 16-bit ISA Bus Expansion Slots
p. 23 32-bit PCI Bus Expansion Slots
p. 25 Keyboard Connector (5-pin Female)
p. 25 Floppy Drive Connector (34-1pin Block)
p. 26 Parallel (Printer) Port Connector (26-1pin Block)
p. 26 Serial Port COM1 & COM2 (10-1pin Blocks)
p. 27 Power Supply, Chassis, CPU Fan Power Leads
p. 27 Chassis Open Alarm Lead (4-1pin Block)
p. 28 Primary / Secondary IDE Connector (40-1pin Blocks)
p. 28 IDE LED Activity Light
p. 29 ATX Motherboard Power Connector (20-pin Block)
p. 29 AT Motherboard Power Connector (12-pin Block)
p. 31 PS/2 Mouse/USB/IR Combo-Connector (18-1pin Block)
p. 31 Second Infrared Port Module Connector (5-pin Block)
p. 31 System Message LED (2 pins)
p. 31 SMI Switch Lead (2 pins)
p. 31 ATX Power & Soft-Off Switch Lead (2 pins)
p. 31 Reset Switch Lead (2 pins)
p. 31 System Power LED Lead (3 pins)
p. 31 Keyboard Lock Switch Lead (2 pins)
p. 31 Speaker Output Connector (4 pins)
p. 32 Wake on LAN Activity Connector (3-pins)
ASUS TX97-L User's Manual
*
13