Installing And Removing A Processor; Installing A Processor; Installing The Processor Fan Heatsink - Intel D845GLVA Product Manual

Intel Desktop Board D845GLVA Product Guide

Installing and Removing a Processor

Instructions on how to install the processor to the desktop board are given below.

Installing a Processor

CAUTION
Before installing or removing the processor, make sure that AC power has been removed by
unplugging the power cord from the computer; the standby power LED should not be lit
(see Figure 2 on page 16). Failure to do so could damage the processor and the desktop board.
To install a processor, follow these instructions:
1. Observe the precautions in "Before You Begin" on page 19.
2. Locate the processor socket and raise the socket lever completely.
3. Install the processor so that the corner with the triangle marking (A) is aligned with the corner
where the lever is attached to the socket (see Figure 5).
4. Lower the lever to its original position.

Installing the Processor Fan Heatsink

The desktop board has an integrated processor fan heatsink retention mechanism (RM). For
instructions on how to install the processor fan heatsink to the integrated processor fan heatsink
RM, refer to the Intel World Wide Web site at:
http://support.intel.com/support/processors/pentium4/intnotes478.htm
22
A
Figure 5. Installing a Processor
OM12078