HP D7171A - NetServer - LPr Configuration Manual page 11

Accessories (continued)
Lift Hooks
Key Features
Each hook can support 500 lbs.
Easy installation
No additional hardware required
Use lift hooks to:
Lift a rack weighing up to
2000 lbs. for repositioning
Rail Spacers
The Rack System/E and /U design
includes a recess of 1/2 inch on
the inside mounting surface of
each column to support mounting
full-width products. Spacers are
used with old legacy rackmount
kits to fill the 1/2 inch recess gap.
Key Features
Die-cast aluminum construction
Mounting hardware included
Use spacers to:
Accommodate legacy rackmount
kits in the HP Rack System/E and /U.
Hardware
Use extra hardware to:
Keep extra mounting hardware
at hand
J1521A Installed on Rack
Product No. Use with
J1521A Rack System/E only
Spacers
Product No. Use with
J1516A Rack System /E
and /U only
Product No. Use with
J1522A All HP racks
and rack
accessories
Lift Hooks
Kit contains
4 lift hooks
Kit contains Use with old legacy products
2 left spacers, J1496A NetServer E rackmount kit
2 right spacers, J1492A NetServer SS/5 rackmount kit
mounting hardware J1456A NetServer LCII rackmount kit
Hardware
Kit contains
10 Torx T25 decorative screws, 10 Torx T25
non-decorative screws with lock washers, 20 U-type,
sheet metal nuts
11