Overview; Serial Interface Specification; Transfer Specification; Connection - Sanyo PLC-ZM5000L - 5000 Lumens Manual

PLC-ZM5000/ZM5000L Basic Serial Command Functional Specifications

1. Overview

0û
These specifications define projector control commands for PLC-ZM5000/ZM5000 L
0û The projector control commands are used to control a projector through RS-232C from a computer.

2. Serial Interface Specification

2.1. Transfer Specification

Item
Synchronous system
Transmission Speed
Data Length
Parity
Stop Bit
Flow Control
1. Transmission speed: initial setting value is 19200.
2. Transmission speed can be changed in service mode.

2.2. Connection

Dedicated serial cable must be used for the connection between computer and projector.
Connect COM port of the computer to CONTROL PORT of the projector.
COM Port (COM1 or COM2) of a computer is specified by control software of the computer.
S p e c i f i c a t i o n
Asynchronous
9600 / 19200
8 bits
None
1
None
PC
COM 1
(D-Sub 9Pin)
5/28
Projector
CONTROL PORT
(D-Sub 9Pin)