Operation Requirements - Sanyo PLC-ZM5000L - 5000 Lumens Manual

PLC-ZM5000/ZM5000L Basic Serial Command Functional Specifications

6.4 Operation Requirements

6.4.1
In the following status of projector, Available Functional Execution Commands are limited.
Projector Status
Standby Mode
Countdown in process
Cooling Down in process
Cooling Down due to Abnormal
Temperature
Abnormal Temperature Status
Abnormal Power Status
Abnormal Filter Status
Power-Save Cooling Down in process
Power Save Status
Cooling Down in process after OFF
operation due to Lamp Failure
Input buttonÿ Mode2 / Mode3 setting
Note) in above status, the projector returns [ACK] [CR] even if it receives the other command.
6.4.2
Functional Execution Commands are invalid when projector is in standby and "Eco" mode
selected in Standby mode menu.
Available Functional Execution Commands
C00: POWER ON
C00: POWER ON → Countdown is terminated
C01: POWER OFF
C02: POWER OFF → Countdown is terminated
C46: ZOOM -
C47: ZOOM +
C4A: FOCUS -
C4B: FOCUS +
C5D: LENS SHIFT UP
C5E: LENS SHIFT DOWN
C5F:LENS SHIFT LEFT
C60:LENS SHIFT RIGHT
When ZOOM+/-, FOCUS +/-, LENS SHIFTUP/
DOWN/LEFT/RIGHT are executed during Countdown
is in process, POINTER UP/DOWN(C3C/C3D)
become effective, and ZOOM/FOCUS/LENS SHIFT
become enable to control by POINTER UP/DOWN.
*Pointer Command(C3A/CA3B/C3C/C3D)
NONE (No Execution)
NONE (No Execution)
NONE (No Execution)
NONE (No Execution)
NONE (No Execution)
NONE (No Execution)
C00: POWER ON
C01: POWER OFF
NONE (No Execution)
Although transmit Input source commands, Input
search does not operate.
11/28