Restarting The Iscsi Or Iscsi/Fcoe Module; Saving Or Restoring The Iscsi Or Iscsi/Fcoe Module Configuration - HP P6000 Installation Manual

Restarting the iSCSI or iSCSI/FCoE module

If you determine that the iSCSI or iSCSI/FCoE modules must be rebooted, you can use HP P6000
Command View to restart the modules. Shutting down the iSCSI or iSCSI/FCoE modules through
HP P6000 Command View is not supported. You must use the CLI to shut down the modules and
then power cycle the array to power on the modules after the shutdown.
To restart a module:
1. Select the iSCSI controller in the Navigation pane.
2. Select Shutdown on the iSCSI Controller Properties window.
3. Select Restart on the iSCSI Controller Shutdown Options window
Figure 39 iSCSI Controller Shutdown Options
To shut down an iSCSI or iSCSI/FCoE module using the CLI:
1. Log in to the serial or management port CLI.
2. Log in to the administrator account.
3. Enter the shutdown command. For example:
MEZ75 login: guest
Password: password
Welcome to MEZ75
MEZ75 #> admin start
Password
MEZ75 (admin) #> shutdown
Are you sure you want to shutdown the System (y/n):
Shutdown completed.
System is in a state that is ready to be powered off.
MEZ75 #>
Connection to host lost.
NOTE:
A wake-up requires a controller power cycle, either by use of the on/off push button or by
removing and re-installing the controller.

Saving or restoring the iSCSI or iSCSI/FCoE module configuration

After the initial setup of the iSCSI or iSCSI/FCoE modules, save the configuration for each module,
in case a service action is required. The Save Configuration function
you to save the configuration from a selected module to a file on the management server. You can
use this file as a restoration point. The Full Configuration Restore function enables the restoration
of the configuration to the point when the configuration was last saved (such as during the LUN
presentation to new initiators), and does not require the iSCSI or iSCSI/FCoE module to be in a
factory reset state. If a new controller is installed, the full configuration can be restored and no
reconfiguration is required. When using HP P6000 Command View to uninitialize a P6300 or
******************************************************
*
* HP StorageWorks MEZ75
*
******************************************************
: ******
A shutdown places the iSCSI or iSCSI/FCoE module into a low power sleep state.
(Figure 39 (page
y
(Figure 40 (page
Restarting the iSCSI or iSCSI/FCoE module
45)).
*
*
*
46)) enables
45