To Edit A Site; Deleting A Site; Adding Storage Systems To A Multi-Site Cluster; Adding Additional Capacity To Existing Sites - HP StorageWorks P4000 User Manual

To edit a site

1. Right-click the Sites node in the navigation window and then select Edit Sites.
2. Select the site you want to edit and then click Continue.
3. Make the desired changes.
4. Click OK when you are finished.

Deleting a site

You would delete a site from a Multi-Site cluster when you are either reconfiguring your SAN or
recovering from a disaster or other failure.
When only one site will be left in the cluster, deleting a site changes the cluster from a Multi-Site cluster
to a standard cluster. If you then remove the storage system(s) assigned to that site, data that resides
on the cluster will restripe.
1. Select the Sites node in the navigation window.
2. Select the site you want to delete in the Details tab, right-click, and then select Delete Site.
NOTE:
If only one site will be left in the cluster, the warning shown in
displayed.
Figure 17 Deleting a site that contains a storage system causes this warning
.
3. Click OK to delete the site.

Adding storage systems to a Multi-Site cluster

After your Multi-Site cluster is configured and operating, you may want to add storage systems to the
cluster for additional capacity or to create a new site. While you can add storage systems to the
Multi-Site cluster at any time, you should add them in a way that does not violate the requirements of
the Multi-Site SAN.
See "Adding a

Adding additional capacity to existing sites

Plan the following items according to your overall Multi-Site SAN configuration:
32 Implementing a Multi-Site SAN
site" on page 31 if you plan to add the storage systems to a new site in the cluster.
Figure 17 on page 32 is