Figure 12 Using the management group wizard to create a Multi-Site SAN
.
NOTE:
You must have at least one storage system for each site in the Available Systems pool before starting.
Creating the management group
The first part of the wizard creates the management group, which includes configuring the optimal
number of managers for the initial setup. After you have the Multi-Site clusters configured, you need
to review the manager configuration and adjust it according to the Multi-Site configuration you have
planned. See
Creating Multi-Site clusters and volumes
The path through the Multi-Site cluster portion of the wizard follows the steps listed below. The steps
are described in greater detail
1.
Create a cluster.
2.
Create a site and then assign storage systems to the site.
3.
Create the additional sites with storage systems, up to a total of three sites.
4.
Add one or more VIPs, depending on the number of subnets you have configured.
5.
Create volumes using the data protection levels dictated by your Multi-Site cluster design.
Using the Multi-Site cluster wizard
After creating the management group, the Create a Cluster window of the wizard is displayed.
24
Implementing a Multi-Site SAN
"Configuring
managers" on page 27.
in"Using the Multi-Site cluster
wizard" on page 24.