*** PLEASE READ THE ENTIRE INSTALLATION INSTRUCTIONS BEFORE PROCEEDING ***
8. Install the removed components (reverse the disassembly procedures)
INSTALLATION NOTE:
Make sure the Fan Connector has NOT become detached from the Engine
Board.
•
Controller Board/Card Cage Assembly
INSTALLATION NOTE:
Make sure to insert the Ribbon Cable through the slot (located above the Fan) in
the Card Cage.
•
SIMMs
•
Network Interface Card (if removed)
INSTALLATION NOTE:
At this time, you should close the upper cover, attach the AC Power Cord, turn
the printer power ON and print the MENU.
-------------------------------------------------------------------------------------------------------------------
Did the MENU print?
NO
- Turn the printer power OFF, detach the AC Power Cord and raise the Upper Cover.
- Remove the Controller Board/Card Cage and make sure all Engine Board Firmware pins
are properly inserted into the Engine IC socket.
YES
- The Program ROM Settings on the Printer Menu will change as follows:
- Turn the printer power OFF, detach the AC Power Cord and raise the Upper Cover.
- Continue to install the removed components.
-------------------------------------------------------------------------------------------------------------------
•
Shield
•
Side Cover
•
AC power cord,
•
Parallel interface cable
•
Network interface cable and 18 inch parallel interface cable (in a network configuration)
9. Close the Upper Cover, turn the printer power ON.
10. Adjust the printer output (refer to the documentation on the OC8 Software CD).
•
Perform the Color Registration adjustment.
•
Perform the Color Balance adjustment.
PU 02.XX
CHANGED TO
or
END OF PROCEDURE
PU 02.25
58341501