Ide Primary Master/Slave - Asus P5Q-VM DO User Manual

PIO Mode [Auto]
Selects the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]
[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
[UDMA3] [UDMA4] [UDMA5]. Only [Auto] is showed if no SATA device is installed
in the system.
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
2.3.5

IDE Primary Master/Slave

The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press <Enter> if you wish to
configure the item.
IDE Primary Master
Device
LBA/Large Mode
Block(Multi-Sector Transfer)
PIO Mode
DMA Mode
Smart Monitoring
32Bit Data Transfer
The BIOS automatically detects the values opposite the dimmed items (Device,
Vendor, Size, LBA Mode, Block Mode, PIO Mode, Async DMA, Ultra DMA, and
SMART monitoring). These values are not user-configurable. These items show
Not Detected if no IDE device is installed in the system.
2-16
: Not Detected
v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
Select the type of
device connected
to the system.
Chapter 2: BIOS setup