Configure The Settings Relating To The Priority Stream [System] - Panasonic WV-SC384 Operating Instructions Manual

Configure the settings relating to the priority stream [System]

Click the [System] tab on the "User mng." page. (☞ Pages 26 and 27: How to display/operate the setup menu)
The description below is the configuration of the priority stream that can transmit images without deteriorating the
image quality and refresh interval even when multiple users access concurrently.
■ Priority stream
[Activation]
Select "On" or "Off" to determine whether or not to use
the priority stream.
Default: Off
Note:
• When "On" is selected for "Activation" of "Priority
stream", number of users who can access the cam-
era may be limited.
[Destination IP address (1)]
Enter the first destination IP address.
[Destination IP address (2)]
Enter the second destination IP address.
[Stream type]
Select either "JPEG", "H.264/MPEG-4(1)" or "H.264/
MPEG-4(2)".
JPEG: JPEG images will be transmitted.
H.264/MPEG-4(1): H.264 (1) (or MPEG-4(1)) images will
be transmitted.
H.264/MPEG-4(2): H.264 (2) (or MPEG-4(2)) images will
be transmitted.
Default: JPEG
Note:
• When "H.264" is selected for "Recording format", it
is impossible to transmit H.264 (2) images. In this
case, "H.264/MPEG-4(2)" is invalidated.
• When "Best effort" is selected for "Transmission pri-
ority" of "H.264 (MPEG-4)", bit rate will vary
between the maximum and minimum rates while
images are being transmitted.
[Refresh interval*]
Select the refresh interval from the following.
This setting is validated only when "JPEG" is selected
for "Stream type".
SW395 SC385
0.1 fps/ 0.2 fps / 0.33 fps / 0.5 fps / 1 fps / 2 fps /
3 fps / 5 fps / 6 fps / 10 fps / 12 fps *(PAL only)/
15 fps * /30 fps *
SC384
0.1 fps / 0.2 fps / 0.33 fps / 0.5 fps / 1 fps / 2 fps /
3 fps / 5 fps / 6 fps */ 10 fps */ 12 fps *(PAL only)/
15 fps * / 30 fps *
Default: 1 fps
Note:
• When "On" is selected for "H.264 (MPEG-4) trans-
mission", the transmission interval may be longer
than the set value when any value with an asterisk
(*) on the right is selected.
[Image capture size]
Select the image capture size from the following.
When "4:3(VGA)" is selected for "Aspect ratio"
QVGA/ VGA/ 1280x960
When "4:3(800x600)" is selected for "Aspect ratio"
SW395 SC385
QVGA/ 800x600/ 1280x960
When "16:9" is selected for "Aspect ratio"
320x180/ 640x360/ 1280x720
This setting is validated only when "JPEG" is
selected for "Stream type".
Default: 1280x960
89