Panasonic WV-SC384 Operating Instructions Manual page 11

!4 Control pad/buttons (*2)
: Left-click on the control pad to
adjust the horizontal/vertical posi-
tion of the camera (panning/tilting).
Panning/tilting speed will be faster
if a clicked point gets farther from
the center point of the control pad.
It is also possible to pan/tilt the camera by dragging
the mouse.
Zoom and focus can be adjusted by right-clicking.
When an upper/lower area of the control pad is
right-clicked, the displayed image will be zoomed
in/out on. When a left/right area is right-clicked, the
focus will be adjusted to the Near/Far side.
Zoom can also be adjusted using the mouse wheel.
!5 [Brightness] buttons (*2)
Available range: 0 - 255
button: The displayed image will be
darker.
button: The adjusted brightness will
return to the default brightness (64).
button: Image will be brighter.
!6 [Preset] (*2)
Select a preset position from the pull-down menu
and click the [Go] button. The camera will move to
the selected preset position (☞ page 67). "H" next
to the preset position number indicates the home
position. When "Home position" is selected, the
camera will move to the home position. (☞ Page 56)
When "Preset ID" is registered for a preset position,
the registered preset ID will be displayed next to the
preset position number.
!7 Camera title
The camera title entered for "Camera title" on the
[Basic] tab will be displayed. (☞ Page 30)
!8 Alarm occurrence indication button (*2)
This button will be displayed and will blink when an
alarm has occurred. When this button is clicked, the
alarm output terminal will be reset and this button
will disappear. (☞ Page 17)
!9 Full screen button
Images will be displayed on a full screen. To return
to the "Live" page, press the [Esc] key.
The aspect ratio of displayed images will be
adjusted in accordance with the monitor.
@0 Snap shot button
Click this button to take a picture (a still picture).
The picture will be displayed on a newly opened
window. When right-clicking on the displayed
image, the pop-up menu will be displayed. It is pos-
sible to save the image on the PC by selecting
"Save" from the displayed pop-up menu.
When "Print" is selected, printer output is enabled.
Note:
• The following setting may be necessary when using
Microsoft Windows 7 or Microsoft Windows Vista.
Click "Internet Options" on the Tools menu of
Internet Explorer, and then click the [Security] tab.
Select "Trusted sites", and click "Site". Register the
camera address on the "Websites" in the "Trusted
sites" window.
@1 Mic input button (*3)
Turns on/off the audio reception (hear audio from
the camera on a PC). This button will be displayed
only when "Mic input", "Interactive(Full-duplex)" or
"Interactive(Half-duplex)" is selected for "Audio
transmission/reception" on the setup menu.
(☞ Page 72)
When this button is clicked, the button will turn into
the button and audio from the camera will not
be heard.
Audio volume can be adjusted (Low/ Middle/ High)
by moving the volume cursor
@2 Audio output button (*3)
Turns on/off the audio transmission (play audio from
the PC on the unit speaker). This button will be dis-
played only when "Audio output", "Interactive(Full-
duplex)" or "Interactive(Half-duplex)" is selected for
"Audio transmission/reception" on the setup menu.
(☞ Page 72)
The button will blink during the audio transmission.
When this button is clicked, the button will turn into
the button and audio from the PC will not be
heard.
Audio output volume can be adjusted (Low/Middle/
High) by moving the volume cursor
11
.
.