Table of Contents
Advertisement
Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when network failure is detected.
All options are listed as follows:
Enable Alarm Output
Select the item to enable alarm relay output.
Record Stream to SD Card
Select the item and the alarm-triggered recording will be saved into your Micro SD card.
Pre-trigger buffer recording function allows users to check what happened to cause the
trigger. The pre-trigger buffer time range is from 1 to 3 seconds. Select <Upload for __
sec> to set the recording duration after alarm is triggered. The setting range is from 1 to
99999 seconds. Select <Upload during the trigger active> to record the triggered video
until the trigger is off.
NOTE: Please make sure the local recording (with Micro SD/SDHC card) is
activated so that this function can be implemented. Refer to Recording for
further details.
Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP and/or E-Mail
when an alarm is triggered.
Save
Click on the <Save> button to save all the settings mentioned above.
56
Advertisement
Table of Contents
