Table of Contents
Advertisement
Select <Upload for __ sec> to set the recording duration after motion event occurs. The
setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video until the trigger is
off.
NOTE: Please make sure the local recording (with Micro SD/SDHC card)
is activated so that this function can be implemented. Refer to Recording
for further details.
Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send warning messages by FTP and/or E-Mail
when motion is detected.
Upload Image by FTP
Select this item and the Administrator can assign a FTP site and configure various
parameters. When motion is detected, event images will be uploaded to the appointed
FTP site.
<Pre-trigger buffer> function allows users to check what happened to cause the trigger.
The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain amount of images
after motion event occurs.
Check the box <Continue image upload> to upload the triggered images during certain
time or keep uploading until the trigger is off. Select <Upload for __sec> and enter the
duration in the blank. The images of the duration will be uploaded to FTP when the
motion event occurs. The setting range is from 1 to 9999 seconds. Select <Upload
during the trigger active> to make the images keep being uploaded to FTP during the
trigger active until the event stops. Set the Image frequency as the upload frame rate.
The setting range is from 1 frame to 15 frames.
NOTE: Make sure FTP configuration has been completed. Refer to FTP
for further details.
Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and configure
52
Advertisement
Table of Contents
