Laser Devices - Gigabit Ethernet Sfp Option; Radio Frequency Interference Requirements - Fcc - Extreme Networks Summit WM3400 Installation Manual

Regulatory Information
Laser Devices - Gigabit Ethernet SFP
!
Option
Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice
No. 50, dated July 26, 2001.
EN60825-1:1994+ A1:2002 +A2:2001
IEC60825-1:1993+A1:1997+A2:2001
The laser classification is marked on the device.
Class 1 Laser devices are not considered to be hazardous when used for their intended
purpose. The following statement is required to comply with US and international
regulations:
CAUTION
Use of controls, adjustments or performance of procedures other than those specified herein may
result in hazardous laser light exposure.
Radio Frequency Interference Requirements -
FCC
Symbol Technologies Inc.
Tested to Comply
With FCC Standards
For Home or Office Use
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
36
Summit WM3400 Wireless LAN Controller Installation Guide