Table of Contents
Advertisement
Never look at the transmit LED/laser through a magnifying device while the LED or laser is
●
powered on.
Never look directly at a fiber port on the router or at the ends of a fiber cable when they are
●
powered on.
Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the
●
beam when optical connections are unplugged.
Never alter, modify, or change an optical device in any way other than suggested in this
●
document.
SFP (Mini-GBIC), SFP+, and XFP Regulatory Compliance
Extreme Networks pluggable optical modules meet the following regulatory requirements:
Class 1 or Class 1M Laser Product
●
EN60825-1:2007 2nd Ed. or later, European standard
●
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
●
Application of CE Mark in accordance with 2004/108/EEC EMC Directive and the 2006/95/EC Low
●
Voltage Directives
UL and/or CSA registered component for North America
●
47 CFR Part 15, Class A when installed into Extreme products
●
Safety Information for the E4G Series Routers
The statements in this section apply specifically to the E4G series routers.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
●
voltage (TNV-1) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV-1 circuits.
Both LAN and WAN ports may use RJ-45 connectors. Use care when connecting cables.
Never touch uninsulated telephone wires or terminals unless the telephone line has been
●
disconnected at the network interface.
Do not use this equipment near a water hazard, such as a wet wall, drain path, or other source of
●
water.
E4G Series Routers Hardware Installation Guide
Safety Information for the E4G Series Routers
93
Advertisement
Table of Contents
