Physical Details - LevelOne FCS-3051 User Manual

Physical Details

Front
IR LEDs
(FCS-3051 Only)
Light Sensor
Lens
Power LED
(Green)
PIR Sensor
Rear
Power Input
LAN port
Digital
Input/Output
Reset Button
AV
These IR LEDs are designed for the supply of backlighting while
under the low-light environments.
The light sensor can be used to distinguish between light and dark,
as well as determine the intensity of the light.
(FCS-3031) Use board mount lens. You should ensure that the lens
cover remain clean. The image quality is degraded if the lens cover
is dirty or smudged.
(FCS-3051) Use the zoom and focus puller to adjust the image of
the lens. You should ensure that the lens cover remain clean. The
image quality is degraded if the lens cover is dirty or smudged.
On - Power on.
Off - No power.
Blinking - The Power LED will blink during start up. This will take
15 to 20 seconds.
The PIR sensor is designed for human body detection.
Connect the supplied 12V power adapter here. Do not use other
power adapters; doing so may damage the camera.
Use a standard LAN cable to connect your Network Camera to a
10/100BaseT hub or switch.
The GPIO terminal block includes 1 input port and 1 output port.
This button is recessed; you need a pin or paper clip can be used to
depress it. It can be activated at any time the camera is in the
"ready" mode.
•
Reset to manufacturer default valued and reboot. When
pressed and held over 10 seconds, the settings of Network
Camera will be set to their default values.
Note:
After this procedure is completed, all LEDs will blink three times to
confirm that the reset was completed successfully.
Connect the supplied AV cable to the AV port, which will extend
TV out, mic in, and spk out connections.
4