Table of Contents
Advertisement
7. MENU "SET" MODE
The Setup Menu allows a number of the HX400 operating parameters to be
custom-configured for your operating requirements.
The Menu Mode is easy to activate and set, using the following procedure:
1. Turn the transceiver off by rotating the VOL knob fully counter-clockwise.
2. Hold down the
the
key.
3. The Menu item will scroll on the upper left corner of the display and its
current status or value will appear on the large display.
4. Press the
5. Press the
current status or value will blink.
6. Press the
item.
7. After completing your adjustment, press the
ting.
8. If you wish to change another Menu item, repeat steps 4 to 7 above.
9. Press the
BEEP LEVEL
Function: Enables/Disables the Keypad beep.
Available Values: HI / Lo / oFF
Default: HI
LAMP MODE
Function: Selects the Lamp illumination method for the
LCD/Keypad.
Available Values: KEY / Cnt (Continuous) / oFF
Default: KEY
KEY:
Cnt (Continuous): Illuminates the LCD/Keypad continuously.
oFF:
SCAN LAMP
Function: Enables/Disables the Lamp while scanner is
paused.
Available Values: on / oFF
Default: on
Page 28
key, then turn on the transceiver while still holding down
or
key to select the Menu item to be adjusted.
key to enable adjustment of the selected Menu item. The
or
key to select the desired status or value of the Menu
key to exit to normal operation.
Illuminates the LCD/Keypad for 5 seconds when any key is
pressed.
Turns off the backlight for the LCD and keys.
key to save the new set-
HX400
Hide quick links:
Advertisement
Table of Contents
