Troubleshooting Guide - Kenwood KMR-700U Instruction Manual

Troubleshooting Guide
Some functions of this unit may be disabled by
some settings made on this unit.
D .
Cannot set up the subwoofer.
• Cannot set up the low pass filter.
• No output from the subwoofer.
~
• <Subwoofer output> of <Basic Operation> (page 6)
is not set to On.
D .
Cannot set up the subwoofer.
• Cannot set up the High Pass Filter.
• Cannot set up the Fader.
• No Audio control effect on AUX.
• Cannot set up the subwoofer position of Manual
position setting.
~
. <Subwoofer output> of <Basic Operation> (page 6)
is not set to On
• The Dual zone function is enabled.
W
<Basic
Operation> (page 6)
D .
Cannot set up the subwoofer phase.
~
The Low Pass Filter is set to Through.
~
<Audio
Setup> (page 14)
D .
Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear speakers.
~
The Dual zone function is disabled. w<Basic
Operation> (page 6)
26 I
KMR-700U
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
General
D
The Touch Sensor Tone does not sound.
v
The preout jack is being used.
W
The Touch Sensor Tone cannot be output from
the preout jack.
Tuner source
D
Radio reception is poor.
v
The car antenna is not extended.
~.
Pull the antenna out all the way.
Audio file source
D
The sound skips when an Audio file is being
played.
v
The recording condition is bad.
~
Record the media again or use another media.