AudioBahn A4002J Owner's Manual page 13

3. Remote Turn-On Input
To remote or power antenna output of car stereo. This amplifier is turned "ON" remotely when the vehicle's stereo
is turned "ON".
Note: IF YOUR RADIO DOES NOT HAVE +12 VOLT OUTPUT LEAD WHEN THE RADIO IS TURNED ON, THE
"REMOTE" TERMINAL ON THE AMPLIFIER CAN BE CONNECTED TO THE VEHICLE'S ACCESSORY
CIRCUIT THAT IS LIVE WHEN THE KEY (IGNITION) IS "ON".
4. B+ Terminal (Battery Positive)
Due to the power requirements of the amplifier, this connection should be made directly to the positive (+)
terminal of the battery. For a safety measure, install an in-line fuse holder (not included) as close to the battery
positive (+) as possible with an apmere rating not to exceed the total value of fuses in the amp.
5. Input Sensitivity Adjustment
MIN
This control adjusts the amplifier's sensitivity to match the signal strength coming from the source unit. Input
sensitivity is variable from 200 Millivolts to 8 volts. Clockwise increases sensitivity. Counterclockwise decreases
sensitivity. THE KNOB IS NOT A VOLUME CONTROL. A lower signal level will require increased sensitivity for
full power. A higher signal will require decreased sensitivity.
MAX
A2002J
A4002J
A8002J
A8000J
A16000J
CONTROLS & FUNCTIONS
POWER
G N D R E M B A T T
POWER
G N D R E M B A T T
A2002J
A4002J
A8002J
A4004J
A6004J
A8000J
A16000J
A2002J
A4002J
A8002J
A4004J
A6004J
A8000J
A16000J
MIN MAX
MIN MAX
A4004J
A6004J
12