Fcc Warning - Kenwood KDC-BT752HD Instruction Manual

FCC WARNING

This equipment may generate or use radio
frequency energy. Changes or modifications
to this equipment may cause harmful
interference unless the modifications are
expressly approved in the instruction manual.
The user could lose the authority to operate
this equipment if an unauthorized change or
modification is made.
FCC NOTE
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment may cause harmful interference
to radio communications, if it is not
installed and used in accordance with the
instructions. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
■ ■
Increase the separation between the
■ ■
equipment and receiver.
Connect the equipment into an outlet on
■ ■
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
■ ■
TV technician for help.
Contains Transmitter Module
■ ■
FCC ID : RKXFC6000S
Contains Transmitter Module
■ ■
IC : 5119A-FC6000S
IC (Industry Canada) Notice
Operation is subject to the following two
conditions:
(1) This device may not cause interference,
and
(2) this device must accept any interference,
including interference that may cause
undesired operation of the device.
The term "IC: " before the certification/
registration number only signifies that the
Industry Canada technical specification were
met.
CAUTION
¤
This equipment complies with FCC/IC
radiation exposure limits set forth for an
uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines in
Supplement C to OET65 and RSS-102 of the
IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy
that it deemed to comply without maximum
permissive exposure evaluation (MPE). But
it is desirable that it should be installed and
operated keeping the radiator at least 20cm
or more away from person's body (excluding
extremities: hands, wrists, feet and ankles).
Under Industry Canada regulations, this
radio transmitter may only operate using an
antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry
Canada. To reduce potential radio interference
to other users, the antenna type and its gain
should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful
communication.