Table of Contents
Advertisement
Appendix D: Warranty and Liability Policy
Important Safety and Handling Instructions
FCC WARNING
!
This equipment may generate or use radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. There are no
authorized user modifications to this product. Damage, deterioration or
malfunction resulting from: accident, acts of nature, misuse, abuse, neglect,
unauthorized product modification, or failure to follow instructions supplied
with the product may void warranty.
NOTE
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment may cause harmful interference to
radio communications, if it is not installed and used in accordance with the
instructions. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS
Installation Precautions
Mounting location precautions to ensure and observe:
1. The unit is not subject to direct sunlight.
2. The unit is not near heat sources (such as heaters).
3. The unit is not exposed to rain or moisture.
4. The unit is not exposed to excessive dust, sand or dirt.
5. The unit is not subject to excessive vibration.
6. The fuel tank should not be damaged by the tapping screws.
7. There should be no wire harnesses or pipes under the place where you
are going to install the unit.
Page 52
Kenwood Music Keg User Manual
Copyright 2002 Kenwood USA Corporation & PhatNoise Inc.
Advertisement
Table of Contents
