Terminal; Power Management; Direct On; Standby Mode - Panasonic PT-LX30HU Operating Instructions Manual

Setting
Logo PIN code change
J
Logo PIN code can be changed to your desired four-
digit number.
1 ) Press ▲▼ to select [Logo PIN code
change].
2 ) Press the <SELECT> button.
Current logo PIN code dialog box appears.
z
3 ) Press ▲▼ to enter the current code.
The New Logo PIN code input dialog box
z
appears. Set a new [Logo PIN code], a
confirmation box appears, choose [Yes] to set
the new [Logo PIN code].
Attention
Be sure to note the new [Logo PIN code] and keep it on
z
hand. If you lost the number, you could no longer change
the Logo PIN code setting.

Terminal

The [COMPUTER IN 2/MONITOR OUT] terminal on
the back of the projector is switchable for computer 2
input or monitor output.
1 ) Press ▲▼ to select [Terminal] and
then press the <SELECT> button .
2 ) Press ▲▼ to switch the item.
Computer 2
Monitor out
Attention
[Terminal] function is not available when selecting
z
[Computer 2] to the input source. Change the input
source to the others (Computer 1 or Video) so that the
[Terminal] function will be available.

Power management

For reducing power consumption as well as
maintaining the lamp life, the [Power management]
function turns off the projection lamp when the
projector is not operated for a certain period.
1 ) Press ▲▼ to select [Power
management].
2 ) Press ► or the <SELECT> button to
access the submenu.
Mode
J
54
- ENGLISH
Computer input
Monitor out
1 ) Press ▲▼ and then press the
<SELECT> button to select one mode
among the items as below.
Ready
When the lamp has been fully cooled
down, the <STANDBY(R)/ON(G)>
indicator changes to green blinking.
In this condition, the projection lamp
will be turned on if the input signal
is reconnected or any button on the
control panel or remote control is
pressed.
Shut
When the lamp has been fully cooled
down down, the power will be turned off.

Off

[Power management] function is off.
Timer
J
1 ) Press ▲▼ to select [Timer] and then
press the <SELECT> button.
2 ) Press ▲▼ to set the Timer(1~30min).

Direct on

1 ) Press ▲▼ to select [Direct on] and
then press the <SELECT> button.
2 ) Press ▲▼ to switch between [On] and
[Off ].
When this function is set to [On], the projector
z
will be automatically turned on just by
connecting the AC power cord to a wall outlet.
Be sure to turn off the projector properly. If the
z
projector is turned off in the incorrect sequence,
the [Direct On] function does not work properly.

Standby mode

This function can set the electric power when the
projector is standing by.
1 ) Press ▲▼ to select [Standby mode]
and then press the <SELECT> button.
2 ) Press ▲▼ to switch between the items
as below.
Restricts some functions in
Eco
standby mode to reduce power
consumption.
Does not restrict functionality
Network
even in standby mode.