Usb; Serial Ata Interfaces - Intel BOXDQ963FXCK Specification

NOTE
The use of DVMT requires operating system driver support.
1.5.1.3 Configuration Modes
A list of supported modes for the Intel GMA 3000 graphics controller is available as a
downloadable document.
For information about
Supported video modes for the board
1.5.2

USB

The board supports up to 10 USB 2.0 ports, supports UHCI and EHCI, and uses UHCI-
and EHCI-compatible drivers.
The ICH8 provides the USB controller for all ports. The port arrangement is as
follows:
• Six ports are implemented with stacked back panel connectors
• Four ports are routed to two separate front panel USB headers
NOTE
Computer systems that have an unshielded cable attached to a USB port may not
meet FCC Class B requirements, even if no device is attached to the cable. Use
shielded cable that meets the requirements for full-speed devices.
For information about
The location of the USB connectors on the back panel
The location of the front panel USB headers
1.5.3

Serial ATA Interfaces

The board provides four Serial ATA (SATA) connectors, which support one device per
connector.
1.5.3.1 Serial ATA Support
The ICH8's Serial ATA controller offers four independent Serial ATA ports with a
theoretical maximum transfer rate of 3 Gbits/sec per port. One device can be installed
on each port for a maximum of four Serial ATA devices. A point-to-point interface is
used for host to device connections, unlike Parallel ATA IDE which supports a
master/slave configuration and two devices per channel.
For compatibility, the underlying Serial ATA functionality is transparent to the
operating system. The Serial ATA controller can operate in both legacy and native
modes. In legacy mode, standard IDE I/O and IRQ resources are assigned (IRQ 14
and 15). In Native mode, standard PCI Conventional bus resource steering is used.
Product Description
Refer to
Section 1.2, page 15
Refer to
Figure 15, page 49
Figure 16, page 50
25