2.
Press in on the smart card reader (1), and then lift the reader slightly upward (2) while pulling it
out of the slot (3).
Reverse this procedure to install the smart card reader assembly.
ExpressCard assembly
Description
ExpressCard assembly
Before removing the ExpressCard assembly, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Remove the bottom door (see
b.
Hard drive (see
c.
Optical drive (see
d.
Fan (see
e.
Heat sink (see
f.
Modem module (see
Battery on page
Bottom door on page
Hard drive on page
Optical drive on page
Fan on page
63)
Heat sink on page
Modem module on page
41).
48).
53)
49)
64)
62)
Component replacement procedures
Spare part number
642763-001
93