HP Z420 Installation Manual page 5

Connecting pre-installed data cables
HP Z600 and HP Z620 Workstations have internal hard drive bay data cables pre-installed on the
system board. For workstations with this cabling configuration, use the following procedure to connect
internal hard drives to the RAID controller card.
1.
Locate and disconnect the hard drive cables from the system board.
Figure 2 Reconnecting the data cables to the RAID controller card (1 of 2)
Figure 2 Reconnecting the data cables to the RAID controller card (2 of 2)
Step 3—Configuring the cabling
5