Step 1-Preparing For Component Installation; Accessing The Internal Components Of The Computer - HP Z200 - Small Form Factor Workstation Installation Manual

Step 1—Preparing for component installation
NOTE: Computer models vary. All illustrations are examples only.

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and
replacement procedures in the service guide for your computer at
manuals.
2. Power down the computer, and then disconnect the power cord.
3. Power down all external devices, and then disconnect them from the computer.
4. Remove the side access panel.
Precautions for handling the drive
●
Do not move the drive during operation.
●
Avoid placing the drive in a location that is subject to extreme temperatures or mechanical
vibration.
●
Keep the original packing materials for future transportation of the drive.
●
If any object or liquid falls into the cabinet, immediately unplug the computer and have it checked
by an authorized service provider.
Step 2—Preparing and installing the hard drive
Identify your installation type from among the three types of internal hard drive installations detailed in
the following sections.
1. Computers with drive carriers that provide blind-mate docking.
2. Computers with carrier rails that snap onto the hard drive.
3. Computers that use guide screws installed in the hard drive.
Throughout this document, all references to hard drives include solid state drives.
Computers with drive carriers that provide blind-mate docking
1. If a card support interferes with access to the system board connectors, remove it.
ENWW
http://www.hp.com/support/
Step 1—Preparing for component installation 3