HP Xw6600 - Workstation - 2 GB RAM Installation Manual page 13

3. On the workstation 3.5-inch hard drive power supply wiring harness, use the remaining two in-line
connectors originally dedicated to the two upper 3.5-inch hard drive bays to provide power to SFF
hard drive number 4 and number 5 (as shown in the following figure).
Figure 13
xw8600 Workstation only)
4. Configure the second adapter power cable (supplied with the second bay converter kit) to provide
power to SFF hard drive number 6 as follows (see the following figure):
a. Attach the white 4-pin connector (B) to the white mating four-pin connector (C) on the adapter
power cable installed earlier for the first SFF hard drive carrier.
ENWW
Power and SATA data cable connections to six SFF hard drives by drive number (HP
Step 3–Configuring a second SFF hard drive carrier for the HP xw8600 Workstation 13