HP Xw4550 - Workstation - 2 GB RAM Installation Manual page 7

2. Select the data cable for the workstation from those shipped with the hard drive.
a. Connect one end to port 0 on the SAS RAID controller card
b. Attach the other end of the data cable to the data cable connector on the primary hard
drive
Figure 7
3. Attach any subsequent hard drives to ports 1–3 on the RAID controller card.
Figure 8
4. Continue with
Connecting the LED activity indicator
This section applies to all HP workstations shown above.
Attach one end of the hard drive activity LED cable to the RAID controller
of the hard drive activity LED cable to the hard drive LED activity connector on the system board
HP xw6000 series workstation system board is shown in the illustration for reference.)
NOTE: To locate the hard drive activity LED (HDD-LED) connector on the system board, see the
service label inside the workstation side access panel. Use the LED cable appropriate for the
workstation.
ENWW
.
2
Attaching the data cable
RAID controller ports
Connecting the LED activity indicator on page
.
7.
card. Attach the other end
Step 3—Configuring the cabling
. (An
2
7