Connecting blind-mate data cables
HP
600 Workstations have pre-installed blind-mate cabling plugged into the system board. For
workstations with this cabling configuration, use the following procedure to connect internal hard drives
to the RAID controller card.
NOTE:
To connect hard drives located in the optical bays of HP
standard data cables on page
1.
Locate and disconnect the HDD BAY 0 cable from the system board.
NOTE:
Figure 3
2.
Connect the HDD BAY 0 cable to Port 0 on the RAID controller card.
Figure 4
ENWW
6.
This procedure assumes that the primary hard drive is located in HDD-BAY-0.
Locating the hard drive cables on the system board
SAS-SATA controller ports
600 Workstations, see
Step 3—Configuring the cabling
Connecting
5