Installing Components Without The User Interface; Troubleshooting - HP VL400 - Vectra - 64 MB RAM Administrator's Manual

Log File

Troubleshooting

Information
2 Local Automatic Installation

Installing Components Without the User Interface

Installing Components Without the User Interface
You can install individual drivers or software utilities from the Image
Library CD-ROM. To do this, locate the desired component for your
operating system, then run the
For more information about the directory structure of the CD-ROM,
refer to page 14.
Troubleshooting
If you encountered any problems installing a component, you can try
•
to install it manually using the installation files that were copied to
the target PC's hard disk in the
If you encountered any problems installing the LAN driver, you must
•
first remove the driver before trying to install it again. For example,
to do this in Windows NT 4.0, click
, double-click
Panel
driver and click
Remove
After each component installation, the Image Library verifies that the
component installed correctly. These results are written in the log file
(
ImageLibrary.log
In fact, the log file contains a complete trace of the installation process.
Therefore you should consult the log file for valuable troubleshooting
information.
34
Setup.exe
\Masters
Start
, click the
Network
.
, located in the hard drive's root directory).
file.
directory.



Settings Control
tab, select the
Adapters