Table of Contents
Advertisement
Power button board
Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Memory module/wireless module compartment cover (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
To remove the power button board:
1.
Position the top cover upright.
2.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the power button board to the
top cover.
Battery on page
32), and then remove the following components:
Hard drive on page
46)
Keyboard on page
51)
Top cover on page
55)
Spare part number
689686-001
WLAN module on page
Component replacement procedures
41)
59
Advertisement
Table of Contents
