Table of Contents
Advertisement
Display subcomponents (bezel, webcam, panel)
This section describes removing display subcomponents that do not require that you remove the
entire display assembly from the computer. You can remove the display bezel, webcam/microphone
module, and display panel while the display assembly is still attached to the computer.
To remove the remaining display subcomponents, including the hinge covers, hinges, cable,
antennas, and enclosure, you must remove the entire display assembly from the computer. See
Display assembly on page 69
entirety.
Description
39.6-cm (15.6-inch), HD, LED, BrightView display panel
Display bezel for use with Compaq models
Display bezel for use with HP models
Webcam/microphone module
Before removing the display bezel, webcam/microphone module, and display panel while the display
assembly is still attached to the computer, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
To remove the display bezel, webcam/microphone module, and display panel while the display
assembly is still attached to the computer:
1.
Remove the two Mylar screw covers (1) and the two Phillips PM2.5×4.0 screws (2) that secure
the display bezel to the display assembly. The Mylar screw covers are included with the display
bezel spare part kit.
for more information about removing the display assembly in its
Battery on page
32).
Spare part number
689690-001
689676-001
689675-001
685112-001
Component replacement procedures
33
Advertisement
Table of Contents
