Network Connection - Sony BDP-S1100 Operating Instructions Manual

Network connection

The player cannot connect to the
network.
, Check the network connection
(page 14) and the network settings
(page 24).
The message [A new software version
is available. Please go to the "Setup"
section of the menu and select
"Network update" to perform the
update.] appears on the screen when
turning the player on.
, See [Network Update] (page 20) to
update the player to a newer software
version.
Control for HDMI (BRAVIA
Sync)
The [Control for HDMI] function does
not work (BRAVIA Sync).
, Check that [Control for HDMI] in
[HDMI Settings] is set to [On]
(page 23).
, If you change the HDMI connection,
turn the player off and on again.
, If power failure occurs, set [Control
for HDMI] in [HDMI Settings] to
[Off], then set [Control for HDMI] in
[HDMI Settings] to [On] (page 23).
, Check the following and refer to the
instruction manual supplied with the
component.
– the connected component is
compatible with the [Control for
HDMI] function.
– the connected component's setting
for the [Control for HDMI] function
is correct.
28
, When you connect the player to a TV
through an AV amplifier (receiver),
– if the AV amplifier (receiver) is not
compatible with the [Control for
HDMI] function, you may be unable
to control the TV from the player.
– if you change the HDMI
connection, disconnect and
reconnect the AC power cord, or a
power failure occurs, try the
following:
1
selector of the AV amplifier
(receiver) so that the picture from
the player appears on the TV screen.
Set [Control for HDMI] in
2
[HDMI Settings] to [Off], then set
[Control for HDMI] in [HDMI
Settings] to [On] (page 23). Refer to
the instruction manual supplied
with the AV amplifier (receiver).
The System Power-Off function does
not work (BRAVIA Sync).
, Check that [Control for HDMI] and
[Linked to TV-off] in [HDMI Settings]
are set to [On] (page 23).
Others
Playback does not start from the
beginning of content.
, Press OPTIONS, and select [Play from
beginning].
Playback does not start from the
resume point where you last stopped
playing.
, The resume point may be cleared from
memory depending on the disc when
– you open the disc tray.
– you disconnect the USB device.
– you play other content.
– you turn off the player.
Switch the input