Enabling Or Disabling Connection Management - Teradici t310 Administrator's Manual

Parameter
4.7.6

Enabling or Disabling Connection Management

The Connection Management Interface option on the Session page lets you enable or
disable connection management and specify the IP address of the connection manager that is
not VMware View.
In a managed connection, an external connection manager server:
TER0606004 Issue 16
Description
The following are Error messages:
You have been disconnected.
l
Unable to connect (0x1001). Please contact your IT administrator.
l
Unable to connect (0x1002). Please contact your IT administrator.
l
Session closed remotely.
l
Session closed remotely (unknown cause).
l
You have been disconnected due to a configuration error
l
(0x100). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x201). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x300). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x301). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x302). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x303). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x305). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x400). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x401). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x402). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x403). Please contact your IT administrator for assistance.
You have been disconnected due to a configuration error
l
(0x404). Please contact your IT administrator for assistance.
You can choose to display:
1. Show All messages – This option shows all disconnect
messages including Info, Warning, and Error messages.
2. Show Error and Warnings Only – This option hides info
messages and displays only error and warning messages.
3. Show Error Only – This option hides Info and Warning messages
and displays only Error messages.
4. Show None – Don't show any disconnect messages.
PCoIP Administrator's Guide
80