Configuring The Device; Initial Setup Page - Teradici t310 Administrator's Manual

4

Configuring the Device

The Configuration option on the Administrative Web Interface and OSD lets you configure
various aspects for the device. This section describes the full set of configuration options
available from the host and the client.
Note: The OSD configuration options are a subset of the options available in the
Administrative Web Interface. To make changes to the configuration settings you need an
administrative password. You do not need a password to view the Diagnostic and
Information menus.
Firmware 3.3.0 or later lets you disable the OSD and Administrative Web Interface from
the PCoIP Management Console. See sections
4.1

Initial Setup Page

The Initial Setup page contains the configuration parameters that you must set before the
client and host devices can be used. The page simplifies the out-of-box experience and
reduces the time for new users to establish a session between a PCoIP zero client and
PCoIP host card in a remote workstation. More complex environments that use host
discovery or connection management systems require further configuration.
If configured in the firmware defaults, the Initial Setup page appears the first time you log
in. After you click Apply, the Home page appears for subsequent sessions unless the
firmware parameters are reset.
The client and host Initial Setup pages are not identical and provide parameters that apply
to the client and host respectively.
After you update the settings on this page, click Apply.
TER0606004 Issue 16
PCoIP Administrator's Guide
4.18 and 4.19 for more details.
37